deflection


Also found in: Dictionary, Thesaurus, Medical, Acronyms, Encyclopedia, Wikipedia.
References in periodicals archive ?
Caption: The vortex chamber of the HammerTek deflection elbow protrudes partially beyond the 90[degrees] flow path, causing a sphere of material-in-air to rotate in the same direction as the air stream that powers it, gently deflecting incoming material around the bend without impacting the elbow wall.
Deflection is then calculated using the same Equation 2 (see Equation 3).
The firm initially specified the deflection elbow to reduce wear and downtime, but now also finds that the component reduces degradation and dust by preventing material impact.
The higher biofidelity of the THOR-50M chest resulted in greater chest deflection (Table 6).
w](x, y, z, t) is the deflection inside the soil layer defined as [bar.
where l = original length of compliant beam, w = length of the platform, and 9 = desired angular deflection oftlie platform.
For relative length l / H > 30 it is not need to use relation (13) because good results give calculation of deflection with the technical theory of flexure Eq.
For vertical deflection--which for practical purposes is the one worth worrying about--the amount of deflection changes as you change firing direction.
8] studied the effect of process parameters on warpage defect using simulation and they found that packing pressure was the most important parameter that is affected on the warpage deflection.
The underestimation of long-term losses of the pre-stressing caused especially either by excessive shrinkage or creep of concrete decreases the level of applied pre-stressing and consecutively increases the deflection.
The final inspection conducted by TDOT and Timewell engineers followed TDOT and AASHTO criteria, noting that deflection testing was to occur no sooner than 30 days after installation.
When the planned excavation depth is increased temporarily after the completion of the support wall construction, the deflection and stability of the support wall may not satisfy the demands, so reinforcement measures should be taken to ensure the safety of the excavation.