lag

(redirected from lag screw)
Also found in: Dictionary, Thesaurus, Medical, Financial, Encyclopedia, Wikipedia.

lag

verb dally, dawdle, decelerate, decrease, delay, diiinish in pace, ebb, fail, fall back, fall behind, get behind, go leisurely, hold back, idle, lag behind, linger, lose strength, move slowly, procrastinate, put off, saunter, slow up, take one's time, trail, wane
Associated concepts: implementation date
See also: delay, pause, procrastinate, stall
References in periodicals archive ?
They report medial migration of the lag screw into the pelvis with a sigmoid perforation after 8 weeks.
Testing was performed at two universities in an effort to develop methods for more effectively anchoring deck ledgers to house band joists using commonly available lag screws and bolts.
Madsen JE et al have stated that "Use of a TSP reduced the secondary lag screw sliding as compared with the conventional CHS without affecting fracture healing.
The penetration depth for the withdrawal resistance test of the lag screw joint was 2.
Surgery may significantly influence the incidence of non-union by using a lag screw, which is connected to a side plate secured to the upper femoral shaft, though the effect of the device on the incidence of avascular necrosis is not completely understood (Ort et al.
In this study, nails of similar material design and lag screw angle were used in an attempt to focus on lag screw design and its effect on sliding, by comparing telescoping and non-telescoping lag screws.
239 in) with cut threads was also included as a comparison with the lag screw.
Tenders are invited for Dhs Plating Set, Ss Imported, Comprising Of One Dhs Plate 130/135 Deg 38 Mm Barrel Lengths 4-7 Holes Interchangeable One Lag Screw 12.
The proximal femoral nail is a cephalo-medullary nail in which the larger diameter lag screw has been replaced with a 6.
Measuring 8 inches back from the hinged ends of each 2-by-2, predrill a centered hole for a 1/4- by 2-inch lag screw, then mount the support assembly with a washer on both sides of each 1-by-2 brace.
Tenders are invited for Supply of Dhs Plating Set, Ss Imported, Comprising Of One Dhs Plate 130/135 Deg 38 Mm Barrel Lengths 4-7 Holes Interchangeable One Lag Screw 12.
In this experiment, nails of similar material, design, and lag screw angle were used in an attempt to focus on the effects of lag screw design, as it affects sliding.