dip

(redirected from dip angle)
Also found in: Dictionary, Thesaurus, Medical, Financial, Encyclopedia.
References in periodicals archive ?
In fact, both the fixed boundary conditions at the bottom and rolling conditions at the side of the hanging wall were changed to moving boundary conditions composed of horizontal and vertical displacement with the assumed fault dip angle, see Figure 1.
5 MPa, dip angle [beta] = 45[degrees], wrinkling modes of the buried oil-gas pipeline under different strike-slip fault displacements are shown in Fig.
However, when the dip angle of SN-2 is over 66[degrees], the second discontinuity set will daylight in the slope face of SN-2, in accordance with the additional conditions (0[degrees]<AP< slope dip-5).
a]), lek population and density, five spatial characteristics of the prairie mole cricket leks surveyed and burrow dip angle Grass height ([H.
HOLE CHU W003 was drilled at an azimuth of 160 degrees and a dip angle of -53 degrees to test the eastern limits of the WEST High Grade Zone and to search for additional high grade zones between the WEST and the EAST.
The effect of slope dip angle, friction angle, and cohesion between the neighboring rock slabs and rock elastic modulus on the slope CBH is discussed.
In fact, both the fixed boundary condition at bottom and rolling condition at the side of the hanging wall were changed to moving boundary conditions (composed of horizontal and vertical displacement) with the assumed dip angle for fault (Fig.
2 Table 3 Standard value and upper/lower limit of design variables Variable name Standard Minimum Maximum value value value Upper suspension length, mm 340 300 400 Lower suspension length, mm 510 480 550 Upper suspension landscape 10 8 15 planar dip angle, [degrees] Upper suspension landscape 10 5 15 planar dip angle, [degrees] Table 4 Data comparison before and after optimization Front wheel alignment Before optimization parameters Change scope Variance Kingpin inclination, 9 ~ 9.
Three different possible shapes of subduction of the Nazca plate in the Colombia-Ecuador trench were obtained: The first configuration, in the Cali A segment, the dip angle changes from17[degrees] to 45[degrees] down to a maximum depth of 100km; the second configuration, in the Popayan B and Narino C segments, the dip angle holds approximately constant at 30[degrees] down to a maximum depth of 200 km; and the third configuration, in the Quito D segment, the dip angle changes of 9[degrees] to 50[degrees] to a maximum depth 220 km.
The Rotodip measures the dip angle of a drill hole during the drilling operation.
HOLE CHU E001 was drilled at an azimuth 290 degrees and a dip angle of -55 degrees to test the EAST high grade zone above previously announced drill hole CHU 06-13 (0.